Temperature Control Cap Injection Molding Machine Cold Start Protection

- A variety of text can be switched.

- Fully automatic mode.

- To provide robot interface.

- Automatic movement monitoring with alarm and fault diagnosis.

- Function of slope setting can set the start and stop of movements, so as ensure the smooth movement.

Parts of injection molding machines

Standard equipment:

1) Double cylinder balancing injections

2) High-torque oil-motor preplasticizing

3) Five pivots minus relief angle, double toggles, machine hinge

mold locking

4) Cabinet-type holder integrates the mold plate

5) Oil motor driven gear mold adjusting

6) Storage-type grease lubricating

7) Pressure and flow whole-proportion running

8) High-performance, low-noise oil pump

9) Multi-step pressure and speed adjusting

10) High-precision position linear transducer

11) Digital memory for mold group

Injection unit:

1) Four injection pressures and speeds with three additional pressures and speeds

2) Suck back function

3) Cold start protection

4) Pre-suck back function

5) Linear displacement transducer accurately monitor injection position, providing optimum. injection accuracy and control

6) Temperature control

7) Heating Status indication

Clamping unit:

1) Three clamp close and open pressures and speeds

2) Mold protection function

3) Hydraulic ejector stroke controlled by transducer

4) Automatic hydraulic die-height adjustment driven by planetary gears system

5) Adjustable support under moving platen

6) Automatic high pressure toggle lubrication with low oil level alarm

7) Mechanical, electrical and hydraulic safety interlock devices

8) Linear displacement transducer controls clamping position

Other parts:

1) Independent core in / out pressure and speed

2) Hydraulic unscrewing sequence

3) Hydraulic oil high temperature alarm

4) System pressure gauge

5) Shot counter and reset function

6) Malfunction alarm light

7) Self-diagnostic function

8) Emergency stop buttons placed both front and rear of the machine to provide easy access

Parameter

	Unit	DS-320T
		A	B	C
Injection unit
Screw Diameter	mm	60	65	70
Screw L/D Ratio	L/D	23	21.2	19.7
Shot Size(Theoretical)	cm3	918	1078	1250
Injection Weight	g	806	946	1097
Injection Pressure	Mpa	190	162	140
Plasticizing Capacity	g/s	35	40	43
Screw Speed	rpm	0-200
Clamping unit
Clamp Tonnage	KN	3200
Toggle Stroke	mm	590
Space Between Tie Bars	mm	630*610
Max.Mold Height	mm	650
Min.Mold Height	mm	220
Ejector Stroke	mm	160
Ejector Tonnage	KN	71
Ejector Number	PC	9
Others
Max.Pump Pressure	Mpa	16
Pump Motor Power	KW	30
Heater Power	KW	18
Machine Dimension(L*W*H)	m	6.6*1.8*2.3
Machine Weight(About)	T	10

plastic bottle cap molding machine

benchtop plastic injection molding machine

Temperature Control Cap Injection Molding Machine Cold Start Protection Images