Machine Procedures

Step 1. Put the preform into preform container and the conveyer will take the preform to orientation units automatically.

Step 2. Load the preform at neck up to preform holder, and then preform is conveyed into baking tunnel.

Step 3. After heating, preform is conveyed into the blow station, then close the mold, stretch and blow under low pressure and high pressure, exhaust, open the mold.

Step 4. The finished bottle is taken off by automatic discharging system

Machine Features

• Energy saving
• Easy to operate, just need feeding preform, other work is automatic.
• Suitable for hot filling, PP, PET bottle blowing
• Suitable for different preform neck size, it can change preform jigs very easily.
• Mold replacement very easily.
• Oven design in reasonable, adopt blowing-type, water cooling, air cooling all have. Suitable for hot environment to work, the preform neck can’t distortion.
• The heating lamp adopt infrared quartz lamp, not easy to damager, it is different than semi-auto blowing machine lamp. So it no need frequently to change lamp. The lamp life is long, even it is broken, it can use also.
• Our hand feeding stretch blow molding machine can add autoloader+manipulator to became fully automatic.
• Our Blow Moulding Bottle Machine is more safety and stabilization.
• Our clamping unit adopt clooked arm configuration self-lubricating system. So very stabilization and no noise.

Machine Parametre